What To Do In The Event Of Breakdown Or Leaks; Spare And Wear Parts; Requirements On Trained Engineers; Liability - flamco Meibes MeiFlow TOP S Montageanleitung

Life-threatening electric shocks can be caused by splashing water/condensation. Escaping water
can also render the safety devices inactive.
Any changes made to the pump group that have not been authorised by the manufacture will
invalidate any warranty claims. The device has been built according to the state of the art and
in accordance with recognised safety regulations.

1.6 What to do in the event of breakdown or leaks

• Close media lines using the appropriate valve.
• Contact a suitably trained expert or customer service of the manufacturer.
The device will only be cleared for operation again when the trained engineer has remedied the
fault and restored the device to its intended condition.

1.7 Spare and wear parts

All spare and wear parts used must correspond to the technical requirements defined by Meibes
System-Technik GmbH. This is guaranteed only with genuine spare parts. The manufacturer is not
liable for damage caused by the use of unapproved spare and wear parts or ancillary materials.
Corresponding information on spare and wear parts is available from the manufacturer on request.

1.8 Requirements on trained engineers

A trained expert must have undergone advanced technical training and have sufficient experience to
independently perform complicated tasks or work associated with residual hazards. Such experience
will in each instance refer to a specialism, e.g. maintenance, working on electrical systems, systems
mechanic for sanitary, heating and air conditioning technology. In preparation for impending work,
a trained expert must be able to correctly estimate the feasibility, risks and hazards as well as the
equipment required. A trained expert is expected to be able to understand complex, minimally
prepared plans and descriptions, and to obtain missing and required detailed information
by suitable means.
The trained expert must be able to restore and check the intended condition of a system.
A worker can be a trained expert in several fields.
For work on the electrical equipment, only trained electricians according to DGUV regulation 3 may
be used.

1.9 Liability

We reserve all copyrights to this document. Misuse thereof, in particular reproduction or disclosure
to third parties, is prohibited. These installation and operating instructions must be given to the
customer. The technician carrying out and/or authorising the work (e.g. installer) must explain the
functioning and operation of the system to the customer in a readily comprehensible way.
We reserve the right to change designs and technical specifications of our products.
9