flamco MeiTronic W10B Bedienungsanleitung Seite 56

EN
SERVICE SETTINGS FOR BOILERS
Para- Parameter name
meter
S5.1 MAXIMUM
BOILER
TEMPERATURE
S5.2 BURNER
HYSTERESIS
AND
OPERATION
MODE
S5.3 BOILER
TEMPERATURE
INCREASE FOR
CIRCUIT 1
S5.4 BOILER
TEMPERATURE
INCREASE FOR
CIRCUIT 2
S5.5 BOILER TEMP.
INCREASE
FOR D. H. W.
WARMING
S5.6 BOILER
STAND-BY
AT MIN.
TEMPERATURE
BURNER
S5.7
SWITCH-OFF
BY SOLID FUEL
BOILER TEMP.
INCREASE
56
SERVICE PARAMETERS
Parameter description
Setting of maximal liquid fuel boiler
temperature.
Setting of burner operation mode
and hysteresis.
-1- Relay is energized if there is no
demand for heating, regardless to
heat source temperature. This way
we block operation of heat sources
with independent controller. Such
control is required for Rotex boilers.
0- relay is energized when there is
need for heating, regardless to heat
source temperature. This way we
activate operation of independent
heat sources, such as (wall hung gas
boiler or heat pump).
1 ÷ 20- burner control hysteresis.
Setting of boiler temperature in-
crease in comparison with calculated
stand-pipe temperature for circuit 1.
Setting of boiler temperature
increase in comparison with
calculated stand-pipe
temperature for circuit 2.
Setting of boiler temperature
increase in comparison with
requested d. h. w. temperature.
Setting of boiler stand-by at
min. boiler temperature.
This setting has affect only if
heating operation mode is active.
Setting of solid fuel boiler
temperature increase that causes
liquid fuel boiler to switch off.
Monitoring period is 2 minutes.
Setting range Default
setting
60 ÷ 160 °C 90
-1- SWITCH- 8
OFF
0- SWITCH-
ON
1- 20 °C- HYS-
TERESIS
0 ÷ 25 °C 5
0 ÷ 25 °C 5
0 ÷ 25 °C 10
0- ON 2
1- DAY TEMP.
PERIOD
2- OFF
0- NO 4
1 ÷ 5 °C
Service setting manual