Marking And Description Of Temperature Sensors; Sensor Simulation - flamco MeiTronic W10B Bedienungsanleitung

BASIC DESCRIPTIONS OF
EN
CONTROLLER OPERATION
MARKING AND DESCRIPTION OF TEMPERATURE
SENSORS
Temperature sensors, which contain Pt1000 sensor elements, are marked with »XX/Pt«.
TABLE: resistance of Pt1000 temperature sensors
Temperature Resistance
[°C] [Ω]
-20 922
-15 941
-10 961
-5 980
0 1000
5 1020
10 1039
15 1058
20 1078
25 1097
30 1117

SENSOR SIMULATION

The W.. controller has a special function installed, which enables simulations of all sen-
sors. With the help of this function, users can test controller operation.
This function is intended for the case of start-up, maintenance or testing of a
controller. Sensor simulation is activated by selecting the screen with hydraulic scheme
display with the
The controller will switch over to the simulation operation mode.
Move between sensors by pressing the
With buttons
The simulated sensor mark will change from T to S.
Simulation operation mode is deactivated by pressing the
if no button is pressed for more than 5 minutes.
84
Temperature Resistance
[°C] [Ω]
35 1136
40 1155
45 1175
50 1194
55 1213
60 1232
65 1252
70 1271
75 1290
80 1309
85 1328
button. Press the
and set the temperature value for each selected sensor.
Temperature Resistance
[°C] [Ω]
90 1347
95 1366
100 1385
105 1404
110 1423
115 1442
120 1461
125 1480
130 1498
135 1515
140 1536
button and hold it for 10 seconds.
button.
button for 10 seconds or
Temperature Resistance
[°C] [Ω]
145 1555
150 1573
155 1592
160 1611
165 1629
170 1648
175 1666
180 1685
185 1703
190 1722
195 1740
Service setting manual