flamco MeiTronic W10B Bedienungsanleitung Seite 43

GENERAL SERVICE SETTINGS
Para- Parameter name
meter
S1.1 HYDRAULIC
SCHEME
CODE FOR
S1.2
UNLOCKING
THE SERVICE
SETTINGS
TEMPERATURE
S1.3
SENSOR TYPE
S1.4 T1 SENSOR
FUNCTION
Service setting manual
SERVICE PARAMETERS
Parameter description
Selection of hydraulic scheme.
This setting enables the change of
code which is necessary to unlock the
service settings (S and F parameters).
WARNING! Keep new code on a safe
place. Without this code is impossible
to change service settings.
Selection of temperature sensors
Pt1000 or KTY10.
Selection of function for sensor
connected to input T1.
0- No sensor.
1- RF, room sensor in circuit 1
2- EF1, sensor for limitation of max.
floor temperature in circuit 1. Max.
floor temperature is set with
parameter S2.11.
3- RLF1, return pipe sensor in circuit
1. Activates limitation of difference
between stand and return pipe and
by that the limitation of max. heating
circuit power. Max. difference is set
with parameter S2.14.
4- KTF, sensor in solar collectors.
Activates the solar differential
thermostat. (Cold sensor for
differential thermostat is T8, pump
is controlled with output R6,
operation mode is set with
parameters P6 and S6).
5- KF2, sensor in solid fuel boiler.
Activates the solid fuel boiler
differential thermostat.
(Cold sensor for differential
thermostat is T8, pump is controlled
with output R6, operation mode is
set with parameters P6 and S6).
EN
Setting range Default
setting
depends on /
type of
controller
0000 - 9999 0001
0- PT1000 0
1- KTY10
0– NO 1
SENSOR
1- RF1
2- EF1
3- RLF1
4- KTF
5- KF2
6- BF3
7- SF3
8- BF2
9- AGF
10- RFHP
11- RLKF
12- AGFTK
43