Motor makes
excessive noise
The motor does
not reach its full
power.
Motor overheats
easily.
Saw cut is rough
or wavy
Workpiece pulls
away and/or
splinters
78 | GB
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
Coils damaged,
motor defective
Circuits in the net-
work are overload-
ed (lamps, other
motors, etc.)
Overloading of the
motor, insufficient
cooling of the
motor
Saw blade dull,
tooth shape not
appropriate for the
material thickness
Excessive cutting
pressure and/
or saw blade not
suitable for use
Arrange for inspection of
the motor by a specialist
Do not use any other
equipment or motors on
the same circuit
Avoid overloading the
motor while cutting, re-
move dust from the motor
in order to ensure optimal
cooling of the motor
Re-sharpen saw blade
and/or use suitable saw
blade
Insert suitable saw blade