Scheppach MST254 Original Bedienungsanleitung Seite 61

19 Only use the supplied saw blade for cutting wood, never for the
processing of metals.
20 Only use saw blade diameters in accordance with the markings on
the saw.
21 Use additional workpiece supports, if required for workpiece stability.
22 Workpiece support extensions must always be secured and used
during work.
23 Replace table inserts when worn!
24 Avoid overheating of the saw teeth.
25 When sawing plastic, avoid melting of the plastic.
Use the appropriate saw blades for this purpose. Replace damaged
or worn saw blades immediately.
When the saw blade overheats, stop the machine. Allow the saw
blade to cool down before using the machine again.
Attention: Laser radiation
Do not stare into the beam
Class 2 laser
Protect yourself and you environment from accidents using suit-
able precautionary measures!
• Do not look directly into the laser beam with unprotected eyes.
• Never look into the path of the beam.
• Never point the laser beam towards reflecting surfaces and persons
or animals. Even a laser beam with a low output can cause damage
to the eyes.
• Caution - methods other than those specified here can result in dan-
gerous radiation exposure.
• Never open the laser module. Unexpected exposure to the beam
can occur.
• The laser may not be replaced with a different type of laser.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
GB | 61