Cleaning; General Maintenance; Transport; Storage - Parkside PNTS 250 C2 Originalbetriebsanleitung

Cleaning

Do not use cleaning agents or sol-
vents. Chemical substances may at-
tack plastic parts of the equipment.
Never clean the equipment under
running water.
• Clean the equipment thoroughly after
each use.
• Clean the surface of the equipment with
a brush or cloth.

General maintenance

Before each use, check the equipment
for obvious defects such as loose, worn
or damaged components and check that
screws or other parts are sitting correctly.
In particular, check the grinding disc. Re-
place damaged parts.

Transport

Switch off the device and unplug
the mains plug.
Allow the device to cool
down.
The grinding disc still runs
even after the device has
been switched off. There is a
risk of injury.
• Carry the device with two hands.
Grip it at the device base and motor
housing.

Storage

• Empty the water tank (
storage: Pull the rubber closure (
from the drain opening of the water
tank and allow the water to drain off
• Store the appliance in a dry place well
out of reach of children.
• Grinding discs must be stored dry and
upright and are not to be stacked.
Waste disposal
and environmental
protection
Be environmentally friendly. Return the
tool, accessories and packaging to a recy-
cling centre when you have finished with
them.
Machines are not to be place with
domestic waste.
Recycle the corrugated
cardboard outer packaging in an
environmentally friendly manner.
• Hand over the device at an utilization
location. The plastic and metal parts
employed can be separated out into
pure materials and recycling can be
implemented. Ask your Service Center
about this.
• Defective units returned to us will be
disposed of for free.
GB IE
13) before
11)
33