Transport; Cleaning And Maintenance; Cleaning; Maintenance - Parkside PSBS 240 C2 Originalbetriebsanleitung

GB IE
10. Test run: Before starting work
and after each change of grind-
ing disk, carry out a test run of at
least 60 seconds with no load.
Switch off the equipment im-
mediately if the disk runs lumpy,
substantial vibrations occur, or
abnormal noises are generated.

Transport

Disconnect the plug before adjust-
ment, maintenance or repair.
The disk will continue to
run after the equipment is
switched off. There is a risk
of injury.
• Carry the device with two hands. Grip
it at the device base and motor hous-
ing.
Cleaning and

maintenance

Disconnect the plug before adjust-
ment, maintenance or repair.
Have any work not described
in these instructions carried
out by a specialist workshop.
Use only original components.
Allow the equipment to cool
before carrying out any main-
tenance and cleaning work.
There is a risk of burns.
Before each use, check the equipment
for obvious defects such as loose, worn
or damaged components and check that
screws or other parts are sitting correctly.
In particular, check the grinding
disk ( 19). Replace damaged parts.
30

Cleaning

Do not use cleaning agents or sol-
vents. Chemical substances may at-
tack plastic parts of the equipment.
Never clean the equipment under
running water.
• Clean the equipment thoroughly after
each use.
• Clean the ventilation openings and the
surface of the equipment with a brush
or cloth.
Maintenance
• The equipment is maintenance free.

Storage

• Store the appliance in a dry place well
out of reach of children.
• Grinding disks must be stored dry and
upright and are not to be stacked.
Waste disposal and en-
vironmental protection
Be environmentally friendly. Return the
tool, accessories and packaging to a recy-
cling centre when you have fi nished with
them.
Machines are not to be place with
domestic waste.
Hand over the device at an utilization
location. The plastic and metal parts em-
ployed can be separated out into pure ma-
terials and recycling can be implemented.
Ask your Service Center about this. Defec-
tive units returned to us will be disposed of
for free.