Maintenance And Cleaning; Cleaning The Dust Filters; Disposal - Parkside PWS 230 D4 Originalbetriebsanleitung

Maintenance and cleaning

WARNING! RISK OF INJURY! Switch
the appliance off and remove the
power plug before starting any
work on the appliance.
■ Do not use any sharp objects to clean the
appliance. Never permit liquids to enter
inside the appliance. Otherwise the appliance
could be damaged.
■ The carbon brushes should only be replaced by
the service centre or an authorised specialist
workshop.
Apart from this, the appliance is mainte-
nance-free.
■ Clean the appliance regularly, preferably imme-
diately after completion of the work.
■ Clean the housing with a dry cloth – do NOT
use petrol, solvents or cleaners which can attack
the plastic.
■ A vacuum cleaner is required for thorough
cleaning of the appliance.
■ Ventilation openings must never be obstructed.
■ Remove any sanding dust stuck to the appliance
with a brush.
NOTE
► Replacement parts not listed (such as carbon
brushes, switch) can be ordered via our
service hotline.
Cleaning the dust filters
The appliance has two dust filters
side. Check and clean the two dust filters
larly. Proceed as follows (see fig. G):
♦ Remove the screw
screwdriver (not in package contents).
♦ Remove the dust filter
necessary.
♦ Reassemble the appliance in the reverse order.
♦ Proceed in the same manner on the other side.
■ 12 │ GB │ IE
All manuals and user guides at all-guides.com
, one on each
regu-
using a standard Phillips
. Inspect it and clean if

Disposal

The packaging consists of environ-
mentally friendly material. It can be
disposed of in local recycling
containers.
Do not dispose of power tools in
the normal domestic waste!
European Directive 2012/19/EU
requires that worn-out power tools are
collected separately and recycled in an environ-
mentally compatible manner.
Your local community or municipal authorities can
provide information on how to dispose of the
worn-out appliance.
Dispose of the packaging in an envi-
ronmentally friendly manner. Note
the labelling on the packaging and
separate the packaging material
components for disposal if necessary. The pack-
aging material is labelled with abbreviations (a)
and numbers (b) with the following meanings:
1–7: plastics, 20–22: paper and cardboard,
80–98: composites.
Your local community or municipal
authorities can provide information on
how to dispose of the worn-out product.
The product is recyclable, subject to
extended producer responsibility and is
collected separately.
PWS 230 D4