Assemble/Adjust Spark Protection; Screw Device On To Workbench; Fill Water Into The Water Tank; Operation - Parkside PNTS 250 C2 Originalbetriebsanleitung

Assemble/adjust spark
protection
1. Screw the spark protection holder (18)
onto the protective hood (
this, use the adjusting screw (21) includ-
ing the snap ring and washer (20/19)
and the nut (17).
2. Adjust the spark protection holder (18)
with the aid of the adjusting screw (21):
The distance between the dry grinding
wheel ( 5) and the spark arrester
holder (18) must not exceed 2 mm.
Periodically readjust the spark pro-
tection in order to offset the wear
and tear of the grinding disc (dis-
tance max. 2 mm).
3. Fold down the spark arrester into work-
ing position. Loosen the adjusting nut
(3) and tilt the spark arrester to the de-
sired position.
Retighten the adjusting nut (3).
Despite the spark protection, you
should always wear protective
glasses when working in order to
avoid eye injuries.
Screw device on to
workbench
1. Remove the rubber foot (10) of the wa-
ter container.
2. Screw the device onto the flat work-
bench with 4 screws and nuts. Insert the
screws through the 4 bore holes (9) on
the base of the device.
The screws and nuts required for as-
sembly are not part of the scope of
delivery.
1. Insert the rubber closure (11) into the
25). For drain opening of the water tank (13).
2. Fill water into the water tank (13) up to
the water level mark

Operation

- Always disconnect the plug from the
- Use only grinding discs and acces-
- Only use grinding tools which bear
- Only use grinding discs where the
- Do not use broken, cracked or other-
- Only use the device when both grind-
- Never operate the device without the
- Always inspect the grinding disc be-
Fill water into the wa-
ter tank
Caution!
Risk of injury!
mains socket before working.
sories recommended by the manufac-
turer. The use of other insertion tools
and other accessories may cause risk
of injury.
information about the manufacturer,
type of binding, dimension and per-
mitted number of revolutions.
printed rotational speed is at least as
high as what has been specified on
the name plate of the device.
wise damaged grinding discs.
Change any damaged or heavily
worn grinding discs.
ing belt and the grinding disc are
assembled.
visual protection disc.
fore starting the device:
Check the distance between the
spark protection holder and grinding
disc as well as workpiece support
and grinding disc (distance maximum
2 mm).
GB IE
.
29