Working Procedures; Sanding Surfaces; Maintenance And Cleaning; Disposal - Parkside PEXS 270 C3 Originalbetriebsanleitung

Working procedures

■ Wait until the power tool has come to a standstill
before putting it down.

Sanding surfaces

♦ Turn on the power tool and ensure that the
whole grinding surface is in contact with the
material being worked. Move it with moderate
pressure over the workpiece.
NOTE
► The removal rate and the sanding pattern are
mainly determined by the choice of sanding
sheet and the contact pressure. Only flawless
sanding sheets achieve good sanding results.
♦ Ensure that you apply even pressure. Use of
excessive pressure does not lead to a greater
sanding efficiency, but rather to increased wear
of the sanding sheet.
♦ Do not use a sanding sheet that has been used
for metal on other materials.

Maintenance and cleaning

The random orbital sander is maintenance-free.
■ Always clean the tool directly after completion
of work.
■ Use a dry cloth to clean the housing. Under no
circumstances should you use fuel, detergents,
solvents or abrasive cleaners.
■ Ensure ventilation openings are always free.
■ Remove any adhering grinding dust with a
brush.
PEXS 270 C3

Disposal

Do not dispose of power tools
in your normal domestic waste!
The adjacent symbol of a crossed-out
dustbin means that this appliance is
subject to Directive 2012/19/EU. This directive
states that this appliance may not be disposed of in
the normal household waste at the end of its useful
life, but must be taken to specially set-up collection
locations, recycling depots or disposal companies.
The disposal is free of charge for the user.
Protect the environment and dispose of this
appliance properly.
Your local community or municipal
authorities can provide information on
how to dispose of the worn-out product.
The packaging is made from environ-
mentally friendly material and can be
disposed of at your local recycling plant.
Dispose of the packaging in an
environmentally friendly manner.
Note the labelling on the packaging
and separate the packaging material
components for disposal if necessary. The packag-
ing material is labelled with abbreviations (a) and
numbers (b) with the following meanings:
1–7: plastics, 20–22: paper and cardboard,
80–98: composites.
The product is recyclable, subject to
extended producer responsibility and
is collected separately.
GB │ IE │ 7 ■