Switching On And Off; Grinding With The Dry Grinding Disc; Grinding With The Wet Grinding Disc - Parkside PNTS 250 C2 Originalbetriebsanleitung

GB IE
- The grinding disc must be replaced
once the spark protection holder and
workpiece support on the grinding
disc do not have distance of max.
2 mm.
- Switch on the equipment only when
it is safely installed on the work sur-
face.
Keep your hands away from
the grinding disc when the
device is in operation. Injury
hazard!
Despite the spark protection, you
should always wear protective
glasses when working in order to
avoid eye injuries.

Switching on and off

Ensure that the mains voltage
matches the specifications on the
rating plate.
Connect the equipment to the
mains.
1. To switch on, press the "I" On switch
( 8) and the device starts up.
2. To switch off, press the "0" off switch
( 8) and the device switches off.
After switching on the device, wait until the
device has reached its max. speed. Only
then must you start with the grinding.
The disc will continue to
run after the equipment is
switched off. There is a risk
of injury.
30
Test run:
Before starting work and after each
change of grinding disc, carry out a test
run of at least 60 seconds with no load.
Switch off the equipment immediately if the
disc runs lumpy, substantial vibrations oc-
cur, or abnormal noises are generated.
Grinding with the dry
grinding disc
• Place the workpiece on the workpiece
support ( 6) and slowly bring it to its
desired angle on the dry grinding disc (
5).
• Move the workpiece slightly from side
to side in order to achieve an optimal
grinding result. This way, the dry grind-
ing disc is worn uniformly. Occasion-
ally, allow the workpiece to cool down.
• Fold the spark protection device (
downwards while grinding in order to
avoid injury from sparks.
Grinding with the wet
grinding disc
• Check the water level in the water tank:
The wet grinding disc (
submerged in water up to the water
level mark
( 13).
• Stand in front of the wet grinding disc
( 1).
• Hold the workpiece with both hands
and lower it slowly onto the wet grind-
ing disc.
• The workpiece can also be supported
on the teeth of the water tank (
1) is to be
on the water tank
2)
13).