Safety Functions - Parkside PKS 2200 A1 Originalbetriebsanleitung

• Lay the extension cable in such a way
that it will not be caught by branches
or similar during sawing.
• Use a RCD (Residual Current Device)
with a rated residual current of 30 mA
or less.
• Comply carefully with maintenance,
control and service instructions in this
manual.
Damaged protective devices and parts
have to be repared or changed except
as noted otherwise in this manual.
• It is recommended that a first-time user
at least practice the cutting of logs on a
saw log or frame.
• Use only approved mains cables of
type H05RN-F that are not more than
75 m long and that are designed for
outdoor use. The wire cross section
of the mains cable must be at least
2.5 mm
. Always roll out the cable reel
2
completely before use. Check the mains
cable for damages.
• Warning! During operation, this power
tool produces an electromagnetic field.
Under certain circumstances, this field
may negatively affect active or passive
medical implants. In order to reduce
the danger of serious or fatal injuries,
we recommend that individuals who
wear medical implants should consult
their doctor and the manufacturer of
the implant before operating the ma-
chine.
• For sowing work on hillsides, always
stand in the area above the log.
To keep total control while sawing
through, reduce the pressure at the end
of the cut without loosening your grip
on the handles of the electric chain
saw. Make sure the saw chain does
not touch the ground. After finishing
the cut, wait until the electric chain saw
comes to a halt before removing it. Al-
ways shut off the engine of the electric
chain saw before switching between
trees.
• Dirt, stones, loose bark, nails, clips and
wires must be removed from the tree.
• Follow the maintenance, control and
service instructions in this manual care-
fully.
Damaged safety equipment and parts
must be repaired or replaced profes-
sionally by our service centre, unless
otherwise indicated in the operating
instructions.
A

Safety functions

1 Rear grip with hand guard (10)
Protects the hand against branches and
boughs in the case of springing away
by the chain.
3 Chain braking lever/
hand guard
Control system, which stops the saw
chain immediately in case of a spring-
back; lever can also be activated
manually; protects the left hand of the
operator if it slides from the front grip.
The motor cannot be turned on if
the chain brake has engaged.
5 Saw chain with small spring-
back
Helps you to catch spring-backs with
specially developed control systems.
17 Metal stop claw
Reinforces the stability when vertical cuts
are carried out and facilitates sawing.
15 Electric motor
Double insulated for safety reasons.
13 On-off switch with safety chain
brake
On releasing the On/Off switch, the
device immediately switches off.
GB IE
41