Further Safety Directions; Safety Functions - Parkside PKS 1600 B2 Originalbetriebsanleitung

Warning! During operation, this
electric tool generates an electro-
magnetic­field­which,­under­certain­
circumstances, may impair the func-
tionality of active or passive medical
implants. To reduce the risk of seri-
ous­or­lethal­injuries,­we­recommend­
that persons with medical implants
consult their doctor and the manu-
facturer of their medical implant
before operating the machine.

Further safety directions

• If the mains cable of this device is da-
maged, it must be replaced by the ma-
nufacturer or their customer service or
by­a­similarly­qualified­person­in­order­
to avoid hazards.
• Lay the extension cable in such a way
that it will not be caught by branches or
similar during sawing.
• Use a residual current device (RCD) with
a­rated­residual­current­of­30 mA­or­less.
• Follow the maintenance, control and ser-
vice instructions in this manual carefully.
Damaged safety equipment and parts
must be repaired or replaced professional-
ly by our service centre, unless otherwise
indicated in the operating instructions.
•­ It­is­recommended­that­a­first-time­user­
at least practice the cutting of logs on a
saw log or frame.
• Use only approved mains cables of type
H07RN-F, that are not more than 75 m
long and that are designed for outdoor
use. The wire cross section of the mains
cable­must­be­at­least­1,0 mm
roll out the cable reel completely before
use. Check the mains cable for damages.
• Warning! During operation, this power
tool­produces­an­electromagnetic­field.­
Under­certain­circumstances,­this­field­
may negatively affect active or passive
medical implants. In order to reduce the
danger­of­serious­or­fatal­injuries,­we­
recommend that individuals who wear
medical implants should consult their
doctor and the manufacturer of the im-
plant before operating the machine.
• For sowing work on hillsides, always
stand in the area above the log. To
keep total control while sawing through,
reduce the pressure at the end of the
cut without loosening your grip on the
handles of the electric chain saw. Make
sure the saw chain does not touch the
ground.­After­finishing­the­cut,­wait­until­
the electric chain saw comes to a halt
before removing it. Always shut off the
engine of the electric chain saw before
switching between trees.
• Dirt, stones, loose bark, nails, clips and
wires must be removed from the tree.
• Do not use the chainsaw without lubri-
cation and top the lubricant up before
the tank is empty.
• Use only the recommended lubricant.

Safety functions

1 Rear grip with hand guard (9)
3 Chain braking lever/
2 . Always
Protects the hand against branches and
boughs in the case of springing away
by the chain.
hand guard
Control system, which stops the saw
chain immediately in case of a spring-
back; lever can also be activated
manually; protects the left hand of the
operator if it slides from the front grip.
The motor cannot be turned on if
the chain brake has engaged.
GB
39