10 Putting Back Into Operation; 11 Disposal; Additional Information For Co2 Values; 13 After-Sales / Service - AL-KO Multitool BC 260 MT Betriebsanleitung

GB
4. Unscrew the spark plug using a spark plug
spanner.
5. Fill a teaspoon of 2-stroke oil into the com-
bustion chamber.
6. Pull the starter cord slowly several times to
distribute the oil inside the engine.
7. Screw the spark plug back in.
8. Cleaning the appliance:
■
Clean the complete appliance and the
accessories using a soft brush or wipe
with a cleaning rag. Do not use petrol or
other solvents!
■
Do not clean the appliance with running
water or high-pressure cleaners.
■
Remove dirt from all appliance openings.
Keep the ventilation slots of the engine
cooling system clear.
■
Keep the handles free from oil and
grease. Water, solvents and polishes
must not be used.
9. Store the appliance in a cool, dry place.

10 PUTTING BACK INTO OPERATION

Thoroughly clean the appliance after each use
and – if present – attach all covers. Store the ap-
pliance in a dry, lockable place out of the reach of
children.
1. Remove the spark plug.
2. Pull the starter cord smartly in order to re-
move residual oil from the combustion cham-
ber.
3. Clean the spark plug, check the electrode
gap and renew the spark plug if necessary.
4. Prepare the machine for use.
5. Fill the tank with the correct fuel/oil mixture.
46

11 DISPOSAL

■
Petrol and motor oil do not belong in
household waste or the public sewer
system, but should be collected and
disposed of separately.
■
Before disposing of the device you must
empty the fuel tank and the engine oil tank!
■
Packaging, equipment and accessories are
made from recyclable materials, and must be
disposed of accordingly.
12 ADDITIONAL INFORMATION FOR
CO2 VALUES
According to Article 43 (4) of Directive (EU)
2016/1628, we are obliged to provide the CO
value determined during the course of the EU
type approval procedure.
The CO values of the Honda engines with EU
2
type approval can be found at
https://www.al-ko.com/shop/media/al-ko-engines/
co2.pdf.
This CO measurement is the result of testing of
2
a (master) engine representative of the engine
type or engine family in a fixed test cycle under
laboratory conditions and does not constitute an
express or implied warranty of the performance
of a particular engine.

13 AFTER-SALES / SERVICE

In the event of questions of warranty, repair or
spare parts, please contact your nearest AL-
KO Service Centre. These can be found on the
Internet at:
www.al-ko.com/service-contacts
Putting back into operation
2
BC 260 MT