Safety Instructions For Trimmer And Brush Cutter; Safety Instructions For The Pole-Mounted Pruner - AL-KO Multitool BC 260 MT Betriebsanleitung

Safety instructions
and thereby result in a deflagration or even
an explosion.
■
Immediately wipe any spilled petrol off the
appliance and the ground. Allow textiles used
to wipe off petrol to dry in a well ventilated
place before disposing of them. Otherwise,
sudden self-ignition may occur.
■
If petrol has been spilled, petrol vapours oc-
cur. For this reason, do not start the appli-
ance at the same location but at least 3 m
away.
■
Avoid skin contact with mineral oil products.
Do not inhale petrol vapours. When filling, al-
ways wear protective gloves. Change and
clean protective clothing regularly.
■
Ensure that your clothing does not come into
contact with petrol. If petrol has got onto your
clothing, change it immediately.
■
Never fill the fuel tank while the engine is run-
ning or hot.
3.2 Safety instructions for trimmer and
brush cutter
■
Always operate the machine with two hands.
■
Always keep hand and feet away from the
cutting device, above all when switching on
the motor.
■
Wait for the cutting device to come to a
standstill after the motor has been switched
off.
■
Only remove cuttings when the motor and
cutting device are at a standstill.
■
Because of danger of cutting injuries, do not
touch the line cutter with unprotected hands.
■
After pulling out a new line, always bring the
appliance into its normal working position be-
fore switching it on.
■
Do not use a metallic cutting line.
■
Always keep the guard plate, spool head and
motor clear of mowing residues.
■
People who are not familiar with the appli-
ance should practice handling it while the
motor is turned off.
■
When working on a slope:
■
Never work on a smooth and slippery
slope.
■
Always mow across the slope, never
down or up.
■
Always stand below the cutting device.
■
After contact with a foreign object:
■
Switch off the engine.
442961_a
■
Check the machine for damage.
■
Attach the blade so that it does not loosen
and fall during operation.
■
Never use the machine in the vicinity of high-
ly inflammable fluids or gases. Risk of explo-
sion and/or fire!
3.3 Safety instructions for the pole-mounted
pruner
■
During pruning, lift the pole-mounted pruner
to a maximum angle of 60°. At a steeper an-
gle, you inevitably get into the area where
cut-off branches can fall. Always stand out-
side this area.
■
Plan an escape route in advance for getting
out of the way of falling branches. This es-
cape route must be free of obstacles such as
sawn-off branches or slippery places that
could hinder getting out of the way.
■
Keep a safe distance from bystanders, ani-
mals, objects or buildings, which is at least
approx. 2.5x the length of the branch to be
sawn off. If that is not possible, saw the
branch off piece by piece.
■
Do not attempt to saw a branch that has a di-
ameter greater than the length of the chain
bar.
■
Do not try to continue a cut that has already
been started.
■
Do not use the pole-mounted pruner for lifting
or moving wood.
■
Make sure that there are no foreign bodies in
the wood (nails, etc.).
■
Avoid moving branches or objects becoming
caught in the saw chain. In this case, immedi-
ately switch off the pole-mounted pruner.
■
Switch off the the basic appliance and push
the protective cover over the saw chain for:
■
Inspection, adjusting and cleaning work
■
Work on the guide rail and saw chain
■
Leaving the attachment
■
Transport
■
Storage
■
Maintenance and repair work
■
Danger
■
Maintain a minimum distance of 15 m to
overhead electrical lines.
37