Coptional Extras - LELY SPLENDIMO 320 FC Betriebsanleitung

Supplement C
C OPTIONAL EXTRAS
Skids
Skids fitted underneath the cutter bar ensure that the SPLENDIMO
mower follows the ground contours more easily. Due to the
streamlined shape of the skids, the mower does not dig into the
ground in case of unevenness while at the same time soil is
prevented from building up underneath the discs. In addition to this,
the skids make sure that the ground pressure is distributed more
evenly across the width of the cutter bar.
Wear plates
To avoid excessive wear and tear of the skids as a result of abrasion,
the SPLENDIMO mower can be equipped with wear plates that are
fitted underneath the skids.
These wear plates can be replaced easily and at low cost. They come
in a thickness of 4 or 8 mm.
Topping skids
By fitting so-called topping skids underneath the skids, the cutter
bar of the SPLENDIMO mower is enabled to mow somewhat higher
above field level in rough conditions. In that case, the mowing
height also increases by approx. 7 cm so that the knives do not dig
into the ground. This may be important when mowing fallow lands
or in nature landscapes.
The turf is spared because the knives do not dig into the ground. The
cutter bar, too, is spared since it is not hit by stones, branches etc..
Agitators
In certain conditions the mower discs may have difficulty in taking
the crop across the cutter bar. Agitators can be fitted on the mower
discs.
These agitators ensure a better grip on the crop resulting in an
improved crop flow.
V belt pulley for 900 or 1,000 r.p.m. of
conditioner rotor
As standard, the conditioner rotor of the SPLENDIMO FC has a
speed of 900 or 1,000 r.p.m.. To be able to ensure a different rotor
speed, another pulley can be made available.
With this pulley the conditioner rotor speed can be adjusted to the
prevailing circumstances (less intensive conditioning or improved
crop transport when having to deal with heavy crops).
Spreading kit
The conditioner of the SPLENDIMO FC mower conditioner is
prepared for fitting so-called spreading fins, which allow the crop to
be dispersed across the full width of the cutter bar. Depending on
weather conditions, one tedding operation may be saved.
E-24