Change Of Grease In Mower Elements - LELY SPLENDIMO 320 FC Betriebsanleitung

Change of grease in mower
7.6
elements
Replace the grease in the mower elements every 500 working hours
or every 1,000 hectares.
Follow the directions listed hereafter:
- Remove the mower disc.
!
If several bearing housings need to be dismounted, care should
be taken that they are fitted back on the original mower
elements.
- Dismount the bearing housing A (fig. 25) from the element. Make
sure that the shims B remain in place.
- Remove the grease from the element. Do not use a solvent since
it may affect the sealing of the bearings and/or rinse the grease fill
out of the bearings.
!
Measure the grease quantity carefully. An incorrect quantity
may cause overheating and damage of the element.
- Fill the elements with 95 grams of grease (Shell Alvania WR 0).
- Place the bearing housing on the element. Turn the hub (C,
fig. 25) so that it is aligned with the hub of the adjacent mower
element (fig. 26).
- Apply Loctite 243 to the thread of the fillister head screws and
tighten them with a torque of 39 Nm (3.9 kgm).
- Check the presence of the O-ring D (fig. 26) in the pressure piece.
- Fit the mower disc. Tighten the castellated nut with a torque of
150-250 Nm (15-25 kgm). Secure the castellated nut with a split
pin. Make sure that the split pin does not protrude above the
pressure piece.
Attention: it is not allowed to turn the nut back; keep turning until
the split pin can be fitted.
39 Nm
(3.9 kgm)
150-250 Nm
(15-25 kgm)
C
A
B
25
D
26
E-19