Transport; Cleaning/Maintenance; General Cleaning And Maintenance Work; Exchanging The Cylinder - Parkside PLV 1500 B1 Originalbetriebsanleitung

Transport

• Adjust the transport position (+10 mm)
setting (see "Setting the Working Posi-
tion") when transporting the implement.
• Lift the implement to transport it over
steps and sensitive surfaces (e.g. tiles).
Use the handle (

Cleaning/maintenance

Work that has not been de-
scribed in these Instructions
must be carried out by a ser-
vicing agency authorised by
us. Only use original parts.
Wear gloves when handling the cyl-
inder.
Prior to all maintenance and clean-
ing work always switch off the
implement, disconnect the plug from
the power socket and wait until the
cylinder is standing still.
Warning! Risk of injury by danger-
ous moving parts!
General cleaning and main-
tenance work
Do not jet water onto the
implement and do not clean
it under flowing water. This
would result in the danger of
an electric shock and the im-
plement could be damaged.
• When work has finished remove plant
residues adhering to the wheels, inside
the ventilation opening, the grass ejector
opening and the cylinder. Do not use
hard or pointed objects for this purpose
as they could damage the implement.
9).
A
• Completely empty the collection bag.
• Always keep the implement clean. Do
not use cleaning agents or solvents.
We cannot be held liable for damage
caused by our implements if they were
improperly repaired, if non-original parts
have been used or if they were used not in
keeping with their intended purpose.
E

Exchanging the cylinder

Switch off the implement, disconnect
the mains plug and wait until the
cylinder is standing still.
Wear gloves when handling the cyl-
inder.
1. Turn the implement over.
2. Loosen the wing screw (19) and pull the
bearing support upwards.
3. Lift the roller (
and pull the shaft out of the hexagon
receptacle (20)..
4. Insert the new cylinder (
reversing the sequence.

Storage

• Store the implement in a dry place well
out of reach of children.
• Allow the motor to cool down before
placing the implement in a closed room.
• Do not wrap nylon sacks around the
implement as this could result in the for-
mation of moisture.
Without wall bracket:
To save space when stored, the han-
dlebar can be folded down after
releasing the tightening levers.
Ensure that the cables are not
squeezed.
GB IE
16/17) diagonally
A
16/17) by
A
NI
15