Problem Solving - Carson Reflex Wheel Ultimate Touch Betriebsanleitung

Problem solving

D
1. Transmitter does not start up.
• The battery is not properly installed.
• Battery is empty.
• The screen flashes when the transmitter is powered
on, and then the transmitter turn itself off imme-
diately. It indicates the electric quantity can´t
support system for a long time and the trans-
mitter will be turned off once it is powered on.
• The battery shrapnel is oxidized and loose
contact.
2. Remote control distance is not enough.
• The wrong position of transmitter antenna or
receive antenna.
• Nearby radio interference.
• Battery is empty.
• Obstacle screens off part of the signal.
3. The transmitter can´t control the receiver.
• The transmitter or receiver enters into the bound
status by accident. The problem can be solved by
powering on again or binding again if necessary.
92 CARSON Reflex Wheel Ultimate Touch 500500516
Downloaded from www.Manualslib.com manuals search engine
4. The transmitter may not accept the data sent
by the receiver sometimes when many people
race at the same time.
• The distance between two transmitters is too
close. Please keep more than 5 meters as far as
possible.
5. The item number of acquisition module does
not appear in the transmitter screen.
• The data cable of acquisition module is connected
to the wrong places.
• The plug of data cable is damaged.
6. The unstable data of speed acquisition.
• The position of speed sensor is not proper, which
drifts too far.
7. The simulator can not be checked on the
computer.
• The USB simulator function of transmitter is not
activated.