Carson Reflex Wheel Ultimate Touch Betriebsanleitung Seite 86

Speed and distance: As shown in picture, if a
D
rotation speed sensor is connected to the receiver,
this function set up the virtual speed and odometers
sensors.
Speed sensor: Select the rotation speed sensor to
use. If none is selected, this function is disabled.
Reset odometer: Touch "Reset odometer 1" or
"Reset odometer 2" to reset the corresponding
odometer.
Odometer 1: it is used for recording the distance
traveled by the vehicle one time
Odometer 2: it is used for recording total distance
traveled by the vehicle.
86 CARSON Reflex Wheel Ultimate Touch 500500516
Downloaded from www.Manualslib.com manuals search engine
Set rotation length: Set the vehicle travel distance
corresponding to one rotation speed sensor. This
distance is used to control the virtual speed and
odometers sensors.
Touch „Set rotation length" to set distance traveled
by the vehicle in one revolution of wheel or gear
(Unit: mm). As shown in picture 2, touch back button
to go back.
Servo frequency selection: Touch the required
frequency to set a new servos frequency or touch
the back button to keep the current servos
frequency.