F) Selecting The Display Value (Gas Consumption/Costs, Forecast) - VOLTCRAFT Energy Control 3000 USB Bedienungsanleitung

f) Selecting the Display Value (Gas Consumption/Costs, Forecast)

• If you have selected a volume such as a gas meter sensor in the display area that is active
at the moment (see b), you can call up the individual measuring and cost values in the
following sequence by briefly pressing the T2 button:
Display sequence for volume and costs
No. Measuring value
1 Volume – current value of last interval
2 Volume – total of last hour
3 Volume – total of last day
4 Volume – total of last week
5 Volume – total of last month
6 Volume – total of last year
7 Volume – total since reset
8 Costs – current value of last interval
9 Costs – total of last hour
10 Costs – total of last day
11 Costs – total of last week
12 Costs – total of last month
13 Costs – total of last year
14 Costs – total since reset
• If the Euro sign is shown instead of m³, the relevant costs are displayed.
• If in addition the word "forecast" is displayed, there is no complete consumption value for
the indicated time period and a forecast is calculated and displayed based on the currently
defined cost factor.
• In the display, the value that was selected last remains visible.
• The relevant unit blinks until another button is pressed or 10 seconds have elapsed without
pressing a button.
52
Active segments
"Value" + m³
"Value" + m³ + h
"Value" + m³ + d
"Value" + m³ + w
"Value" + m³ + m
"Value" + m³ + y
"Value" + m³ + Σ
"Value" + 
"Value" +  + h
"Value" +  + d
"Value" +  + w
"Value" +  + m
"Value" +  + y
"Value" +  + Σ