B) „Power2" Display For Effective Power, Output And Performance Factor; C) „Consumption" Display For Overall Power Consumption; D) „History" Display For Energy Consumption Per Day - VOLTCRAFT Energy Logger 4000 Bedienungsanleitung

b) „Power2" display for effective power, output and performance factor
The „W" effective power displays the actually assumed load. The effective power
is established from the three parameters of current, power and performance factor
„cosPHI".
The „VA" outpur, however, establishes only the product from current and power, which
can result in a deviation from the effective power to the outpur for capacity loads.
Your energy supplier always assumes the effective power as the basis for
calculation (the measurement device is not approved for balancing pur-
poses!).
The MIN/MAX display is carried out as described in the „Power1" display.
To switch the measurement displays, click the „MODE" (5) key for the next or the „Continue" arrow key (7) for the
previous display. Every time you press, you switch the display.
c) „Consumption" display for overall power consumption
This display shows the entire, already used energy in kilowatt hours and the thus
calculated costs for tariffs 1 and 2.
Your energy supplier always states your energy consumption and the tariff
costs in kilowatt hours (kWh) (The measuring device is not approved for
balancing purposes!).
By pressing the „MODE" key for at least 3 sconds, all displays of „Consumption", „History", „ON time" and „Forecast"
are reset to nill, and the „MEM" memory deleted.
To switch the measurement displays, click the „MODE" (5) key for the next or the „Continue" arrow key (7) for the
previous display. Every time you press, you switch the display.
d) „History" display for energy consumption per day
This display shows the already used energy in kilowatt hours „kWh" and the thus
calculated costs for tariffs 1 and 2. The display can be differentiated from the current
day (today) until 9 days in the past.
Via the two arrow keys (3 and 4) the days can be browsed back and forwards. This is
illustrated under the display masking „Today", e,.g. as „1" to „9".
Via this function peak days can be directly analysed on the device.
To switch the measurement displays, click the „MODE" (5) key for the next or the „Continue" arrow key (7) for the
previous display. Every time you press, you switch the display.
28