8. Value on display
D
C
B
A
M
L
K
The meter with item no. 1763394 does not display any symbols, values or measuring
units for the conductivity, TDS (total dissolved solids) and salinity.
9. Setup
a) Inserting/changing the battery
The supplied battery must be inserted into the meter before first use. Proceed as follows:
•
Fully unfold the meter.
•
Open the battery compartment cover (10) on the right-hand side of the meter by turning the
lock with a coin or screwdriver. Then remove the battery cover. Do not remove the cover
with your fingers.
•
Connect the 9 V block battery (included) to the battery connector with the correct polarity
(observe positive/+ and negative/- signs) and store it in the battery compartment.
•
Replace the battery compartment cover and screw it in place. Ensure that the sealing ring in
the battery compartment cover is in the correct position.
E
F
MTC
G
H
J
I
A Calibration error symbol
B CAL calibration symbol
C Measured value
D Operating modes
E Units symbols
F MIN symbol, MAX symbol
G Manual temperature compensation (MTC)
Automatic temperature compensation (ATC)
H Temperature unit (°C or °F)
I
Measured temperature value
J Freeze display AUTO LOCK
K RECALL memory symbol
L STORE memory symbol
M Battery status indicator
29