D) Selecting The Display Value (Energy/Costs, Forecast) - VOLTCRAFT Energy Control 3000 USB Bedienungsanleitung


Notes:
You can only select sensors from which data have already been received.
Unassigned sensor addresses are skipped.
First, the sensors for electrical energy are switched (sensors 1...8), followed
by the volume sensors (1...4).
2. Press T1 and hold
• Change from one display area to the other.
• The sensor address blinks until another button is pressed or 10 seconds have elapsed
without pressing another button.
• Press T1 briefly, sensors are counted up with each press.

d) Selecting the Display Value (Energy/Costs, Forecast)

• In the display area that is active at the moment (see b), you can call up the individual
measuring and cost values in the following order by briefly pressing the T2 button:
Display sequence for energy and costs
No. Measuring value
1 Energy – current value of last interval
2 Energy – total of last hour
3 Energy – total of last day
4 Energy – total of last week
5 Energy – total of last month
6 Energy – total of last year
7 Energy – total since reset
8 Costs – current value of last interval
9 Costs – total of last hour
10 Costs – total of last day
11 Costs – total of last week
12 Costs – total of last month
13 Costs – total of last year
14 Costs – total since reset
48
Active segments
"Value" + kWh
"Value" + kWh + h
"Value" + kWh + d
"Value" + kWh + w
"Value" + kWh + m
"Value" + kWh + y
"Value" + kWh + Σ
"Value" + 
"Value" +  + h
"Value" +  + d
"Value" +  + w
"Value" +  + m
"Value" +  + y
"Value" +  + Σ