ABICAR ADVANCED
6.6.1 Attaching two welding torches
Fig. 10
A 4 × mounting screws, M6 × 20
B Welding torch mount
C Max. area for workpiece
D Stop lever
A
Mount the second welding torch mount (B) using the mounting screws (A).
1
Clamp the welding torch (G) into the welding torch mount (B) using the locking screw (F).
2
Roughly align the welding torch (G) with the stop levers (D).
3
Use the cross slide (E) for fine adjustment.
4
6.7 Adjusting the cross slide
The cross slide must be adjusted according to the welding torch type and diameter. The welding torch
position can be changed in the vertical and horizontal direction during welding using the cross slide.
Fig. 11
A Adjusting screw, vertical
B Bracket, horizontal
A
D
► Turn the adjusting screws (A) and (C) of the cross slide to the left or right.
The brackets (B) and (D) can be adjusted sidewise, or downwards and upwards.
Mounting the second welding torch
B
C
Adjusting the cross slide
6 Putting into operation
E Cross slide
F Locking screw
G Welding torch
max. 75
C Adjusting screw, horizontal
D Bracket, vertical
B
C
D
E
D
F
D
G
EN - 17