Adjusting The Seat Angle - Otto Bock BRAVO Racer Bedienungsanleitung

A
B
6.4 Adjusting the seat angle (Fig. 44, 45, 46)
Slightly loosen the two nuts on the front of the adjustment tube (Figure 44, marking A). Proceed
in the same way on both sides.
Loosen the two outer screws on the back of the clamps that guide the footrest bar and cross
brace as well as the central recessed screws until the cross brace moves easily in the clamp
(Figure 45, marking A/B).
Now change the seat angle by moving the cross brace up and down in the clamps. The driving
axle is the centre of rotation (Figure 46). The angle of the footrest moves automatically with the
seat angle. Once you have reached the desired angle, retighten all screws.
The rear wheel adapter's hexagon exclusively serves the form-fit attachment of frame
INfORMATION
accessories. Never try to loosen this connection using a wrench. The correct torque for the screw
(Figure 44, marking A) is 10 Nm.
42
A
44
A
B
43
45
61