Master FC100 Bedienungsanleitung Seite 89

Assembly Instructions
Step 1: Upright Tubes
• The right side upright tube (19) has the computer cable (A)(87) pre-installed. Lift the
tube off the walking surface and attach it to the base frame. You need to gently pull
on the computer cable as you line up the upright tube, taking the slack out, so the
cable does not get pinched between the tube and the base frame. Assemble one
3/8" x 3-3/4" bolt (104), 3/8" split washer (58) and 3/8" flat washer (59) through the
top hole in the retaining plate (21), and corresponding top hole in the upright tube,
and screw into the base frame. Now install the other two bolts (104) and washers
(58 & 59) and tighten all three securely.
• Install the left upright (18) in the same manner.
• Install the lower side caps (32 & 33) with four M5 x 12mm screws (73).
89
EN