Master FC100 Bedienungsanleitung Seite 104

EN
TREADBELT TRACKING ADJUSTMENT:
The performance of your treadmill is dependent on the frame running on a reasonably
level surface. If the frame is not level, the front and back roller cannot run parallel, and
constant belt adjustment may be necessary.
The treadmill is designed to keep the tread-belt reasonably centered while in use. It is
normal for some belts to drift near one side while the belt is running with no one on it.
After a few minutes of use, the tread-belt should have a tendency to center itself. If,
during use, the belt continues to move toward one side, adjustments are necessary.
TO SET TREADBELT TRACKING:
A 10 mm Allen wrench is provided to adjust the rear roller. Make tracking adjustments
from the left side only. Set belt
speed at approximately 3 to 5 kph.
Remember, a small adjustment can
make a dramatic difference!
Turn the bolt clockwise to move the
belt to the right. Turn the bolt only a
1/4 turn and wait a few minutes for
the belt to adjust itself. Continue to
make 1/4 rotation turns until the belt
stabilizes in the center of the running deck.
The belt may require periodic tracking adjustment depending on use and
walking/running characteristics. Some users will affect tracking differently. Expect to
make adjustments as required to center the tread-belt. Adjustments will become less of
a maintenance concern as the belt is used. Proper belt tracking is an owner
responsibility common with all treadmills.
ATTENTION:
DAMAGE TO THE RUNNING BELT RESULTING FROM IMPROPER TRACKING /
TENSION ADJUSTMENTS IS NOT COVERED UNDER THE WARRANTY.
104