Master FC100 Bedienungsanleitung Seite 105

Service Checklist - Diagnosis Guide
Before contacting your dealer for aid, please review the following information. It may save
you both time and expense. This list includes common problems that may not be covered
under the treadmill's warranty.
PROBLEM
Display does not light
Tread-belt does not stay centered
Treadmill belt hesitates when walked/run on
Motor is not responsive after pressing start
Treadmill will only achieve approximately
10 kph but shows higher speed on display
Tread-belt stops quickly/suddenly when
tether cord is pulled
Treadmill trips on board 15 amp circuit
Computer shuts off when console is
touched (on a cold day) while walking/running
House circuit breaker trips, but not the
treadmill circuit breaker.
SOLUTION/CAUSE
1) Tether cord not in position.
2) Circuit breaker on front grill tripped. Push circuit
breaker in until it locks.
3) Plug is disconnected. Make sure plug is firmly
pushed into
230 VAC wall outlet.
4) Breaker panel circuit breaker may be tripped.
5) Treadmill defect. Contact your dealer.
The user may be walking while favoring or putting
more weight on either the left or right foot. If this
walking pattern is natural, track the belt slightly off-
center to the side opposite from the belt
movement.
See General Maintenance section on Tread-belt
Tension.
Motor drive belt may be loose.
1) If the belt moves, but stops after a short time and
the display shows "LS", run calibration (See
procedure on next page).
2) If you press start and the belt never moves, then
the display shows LS, contact service.
This indicates motor should be receiving power to
operate. Low AC voltage to treadmill. Do not use an
extension cord. If an extension cord is required it
should be as short as possible and heavy duty 16
gauge minimum. Low household voltage. Contact an
electrician or your dealer. A minimum of 220 volt AC
current, 50hz is required.
High belt/deck friction.
High belt/deck friction.
Treadmill may not be grounded. Static electricity is
"crashing" the computer. Refer to Grounding
Instructions on page 4.
Need to replace the house breaker with a "High
inrush current" type breaker (see page 4 for details)
105
EN