Replacement Of Components (Service Concept); Save And Load Of Firmware On Location; Replacement In Special Cases - Bosch Rexroth PRC 7000 Betriebsanleitung

R911172834 / 02 | PRC7000
10.3

Replacement of components (Service concept)

10.3.1

Save and load of firmware on location

10.3.2

Replacement in special cases

The replacement of components is reserved to authorisized staff
(trained maintenance staff or field service). For further instructions refer
to Section 11.Dismantling and replacement.
Inappropriate use of the SD-card!
Damage of the SD-card possible!
The SD-card will only be used in PRC7000 devices.
"
Usage in other devices is not allowed.
"
After replacement of a PRC7000 weld timer please open the cover at
the top right (refer to Fig.8 PRC7000 Interfaces page 216 and XGSD1
Connector SD-card page 228) and remove the SD-card from the old de­
vice.
The SD card has to be pressed first and then pushed out carefully. Then
install the SD-card in the replacement device.
If, in the case of repair, the SD card has been taken from the defective­
timer and placed in the replacement timer, it is necessary to save the
backup, protocol and log files during the first run of the replacement
timer and send them and the timer to be repaired to
Bosch Rexroth AG
­Service­DC-IA/SVF413
Bgm.­Dr.­Nebel­Str. 2
97816 Lohr am Main
GERMANY
Tel. +49 9352 / 40 50 60
service@boschrexroth.de
After replacement of a PRC7000 weld timer it is necessary to load the­
customer­specific parameters. Replacement of the SD card is sufficient
as a rule.
The customer has to save his customer specific data by himself. Bosch
Rexroth does not assume any responsibility for the loss of data and any
consequent damage.
The customer order at DC-IA/SVF4 a replacement component and
send back parallel the defect part. Therefore the customer has to send
the serial number of the defect part to SVF4. A corresponding timer will
be prepared and delivered to the customer.
Bosch Rexroth AG
Service and repair
NOTICE
293 / 334