Bosch Rexroth PRC 7000 Betriebsanleitung Seite 207

R911172834 / 02 | PRC7000
• Comparison between timers and/or backup files
• Start simulation:
- spot selection and schedule start can be initiated by PRI7000
• Online and offline programming (in preparation) is possible.
• Reweld with setup of the fault configuration
- A comment on fault reset is required, if the comment request is
enabled at least one of the fault.
- Reweld is locked, if at least for one of the fault, the reweld inhibit is
activated. Nevertheless, if a „Reset fault with reweld" via the I/O
field or the user interface triggered, this command is as an „Reset
fault with WC" treated. In this case, an additional warning „Reweld
inhibit" is set and logged.
- Decisive for the number of automatic rewelds is the smallest num­
ber that is configured within the existing faults.
- If with a pending fault the UIR control inhibit is activated at reweld,
the UI mode for the performed reweld is blocked and the schedule
run in the base mode.
- If with a pending fault the UIR-monitoring inhibit is activated at
reweld, the UI-monitoring operation to be carried out for the
reweld is blocked and monitored the schedule in the base monitor
mode.
Bosch Rexroth AG 207 / 334
Information on this product