Overview Of The Service Menu - Bosch MS 100 Installationsanleitung

4.4

Overview of the service menu

The menus depend on the installed user interface and the
installed system.
Service menu
Commissioning
...
...
Solar settings
Solar thermal sys installed
Change solar configuration
Current solar configuration
Solar parameters
1) Only available if the MS 100 module is installed in a BUS
system without a heat source (not possible with all user
interfaces).
MS 100
Solar circuit
Speed ctrl. sol.circ.pump
Min. speed sol circ pump
Start diff. sol.circ.pump
Stop diff. sol.circ.pump
Max. collector temp.
Min. collector temp.
Vac. tube pump anti-seize
Southern Europe function
Start temp. S.Eur. fct.
Cylinder
Max. temp. cyl. 1
Max. temp. cyl. 3
Start diff. heat ex.
Stop diff. heat ex.
Frost prot. temp. heat ex.
Solar yield/optimisation
Gross collector area 1
Type collector array 1
Climate zone
Min. DHW temp.
Solar infl. heat. circ. 1
Reset solar yield
Reset solar optimisation
Set temp. Vario-Match-F.
Glycol content
Transfer
Transfer start diff.
Transfer stop diff.
Solar DHW
DHW controller act.
Therm.dis./daily ht cyl1
Therm.dis./daily ht cyl3
Daily heat start time
Daily heat temp.
Start solar thermal system
DHW settings
Change DHW configuration
Current DHW configuration
DHW parameters
Max. DHW temp.
DHW
Circulation time
DHW circ. pump mode
Start frequency DHW circ.
Circulation pulse
Daily heat-up
Daily heat-up time
Return start temp.
Fault display
Keep hot
Diagnosis
...
6 720 815 256-02.1O
2) Only available if the freshwater system is set
(coding switch set to pos. 9)
Commissioning | 35
1)
1)
2)
6 720 815 256 (2014/10)