Beissbarth MT 826 DT Originalbetriebsanleitung Seite 48

en 48 | MT 826 DT | Wheel balancing
i
The rim width can be read off the rim or determined
with the measuring compasses.
Fig. 19: Determining rim data with measuring compasses
1 Rim diameter scale
2 Outer tip for rim diameter
3 Inner tip for rim width
4 Rim width scale
2. Apply the inner tips of the measuring compasses to
the rim flange.
3. Read the value off the rim width scale.
4. Enter the rim width determined.
|
1 695 600 575 2016-08-23
9.3 Measuring unbalance
i
A wheel can only be correctly balanced if all the
settings correspond to the mounted wheel.
i
Measurement can be stopped at any time:
$
Press the < I > key.
$
Press the pedal.
$
Open the wheel guard.
1. Close the wheel guard.
 The unbalance measurement commences auto-
matically.
 On completion of measurement the values of the
651012-11_Sr
balance weights required are shown on the dis-
play.
On left of display inner balancing plane,
on right of display outer balancing plane.
2. Open the wheel guard.
Beissbarth GmbH