Fitting The Wheel Guard - Beissbarth MT 826 DT Originalbetriebsanleitung

4.3

Fitting the wheel guard

i
The back of the MT 826 DT contains 4 blind rivet
nuts countersunk in the housing wall.
1. Fasten the supporting arm to the MT 826 DT.
To do so, screw the 4 supplied Allen screws and 4
washers into the blind rivet nuts and tighten (width
A/F 6).
Fig. 6: Fastening the supporting arm to the MT 826 DT.
1 Supporting arm
2 Allen screw
3 Washer
4 Blind rivet nut
4.4 Fitting monitor
i
The back of the MT 826 DT contains 4 blind rivet
nuts countersunk in the housing wall.
1. Fasten the supporting arm to the MT 826 DT.
To do so, screw the 4 supplied Allen screws and 4
washers into the blind rivet nuts and tighten (width
A/F 6).
1
3
2
Fig. 7: Fastening the supporting arm to the MT 826 DT.
1 Supporting arm
2 Allen screw
3 Washer
Beissbarth GmbH
4
2
3
1
Commissioning | MT 826 DT | 39
2. Attach the rubber ring to the support arm, as shown
in the illustration. Insert the rings between the
mounting plate and the monitor to prevent that the
parts shift.
3. Fasten the monitor to the support arm. For this
purpose, screw on the bracket with 4 screws and 4
washers.
Fig. 8: Fitting monitor
1 Allen screw
2 Washer
en
|
1 695 600 575 2016-08-23