Beissbarth MT 826 DT Originalbetriebsanleitung Seite 37

3.5 MT 826 DT
13
14
Fig. 5: MT 826 DT
Item Designation
1 Monitor
2 Wheel guard
3 Gauge arm (accessory)
4 Vernier caliper (electronic)
5 Cone of drive shaft
6 Pedal
7 Control panel
8 Tray
9 Mains socket
10 On/off switch
11 Centering flange
12 Quick-action clamping nut
13 Manual vernier caliper
14 Measuring compasses
15 Clamping tool holders
Beissbarth GmbH
12
7
15
9
10
15
Function/purpose
Software display (measured values and operating instructions)
R Protection of operator against flying particles (e. g. dirt, water).
R Starting and stopping measurement.
Determination of rim width
R Recording of rim distance and rim diameter.
R Determination of positions for attachment of adhesive weights.
Flange mounting.
Locking of shaft / wheel.
Operation of MT 826 DT.
For storing balance weights and accessories.
Connection for power cord.
Switching MT 826 DT on and off.
Wheel attachment.
Centering and attachment of wheel on cone.
Can be used as substitute if the electronic vernier caliper is defective.
Can be used as substitute if the rim width and rim diameter cannot be recorded
electronically.
For storing accessories.
Product description | MT 826 DT | 37
1
4
8
5
6
en
2
3
11
|
1 695 600 575 2016-08-23