Mounting The Extension; Working Instructions Weed Killer; Cleaning/Maintenance/Storage; General Cleaning And Maintenance Work - Parkside PLHLG 2000 B2 Originalbetriebsanleitung

Mounting the extension

1. Turn the handle (6) on the hot air
blower to the position
chapter "Turning the handle"
2. Insert the extension pipe (9) into
the threaded coupling (12) on
the handle shaft (13) and tighten
the coupling nuts (10).
3. Now, insert the extension pipe
(9) into the threaded coupling
(7) on the device housing (2) of
the hot air blower and tighten
the coupling nuts (10).
4. Guide the mains cable (8) along
the extension handle (9) and fix
it using the two cable clips (11).
5. Guide the mains cable (8)
through the cable strain relief
(14) on the handle shaft (13). At
the height of cable strain relief,
form a loop, which you can
guide through the eyelets on the
cable holder (14) and hang on
the back.
Working instructions
Weed killer
• The conical nozzle (
suited to remove weeds.
• The best time to begin removing weeds
is the spring
• Weed removal is most effective when
the plant is still young.
• The success of actions using the device
will not be immediately visible.
• Depending on the plant type, it may
not respond immediately to the heat for
the recommended exposure time.
- Young, soft-leaved plants are sensi-
tive to the treatment and afterwards
they are no longer viable.
1 (see
).
16) is best
- Hard-leaved grasses are very robust.
They have to be treated more fre-
quently.
- Older plants and plants with hard
leaves, such as thistles, have to be
treated more regularly at 1-2 week
intervals in order to successfully dry
them out.
• The visible part of the plant can also
be scorched for a longer exposure time
during treatment.
• Scorching the plants is not absolutely
necessary. Heating them dries out the
leaves and any weeds die.
• When treating areas filled with roots,
you will have to repeat treatments sev-
eral times in short periods for lasting
success. After this, longer treatment
intervals will suffice.
• With some weeds, you may have to
repeat the treatment.
Cleaning/maintenance/
storage
Ask our service centre to carry out
any work that is not described in
these instructions. Do not try to re-
pair the device by yourself, unless
you have professional training. Use
only original parts.
• Store the device in a dry place and out
of reach of children.
General cleaning and main-
tenance work
• Always keep the device clean. Use a
brush or cloth for cleaning, but do not
use any cleaning agents or solvents.
GB IE NI
11