Surface Nozzle; Spatula Nozzle; Grill Lighter Nozzle; Conical Nozzle - Parkside PLHLG 2000 B2 Originalbetriebsanleitung

GB IE NI
When using the restrictor (19),
pay particular attention to the heat
development at the cutting point. If
in doubt, do not stay in the same
place for too long in order to avoid
overheating the workpiece.

Surface nozzle

Place the surface nozzle (17) on the blow-
off pipe ( 1).
Use the surface nozzle (17) to obtain heat
over a large surface.
It is especially suitable for dissolving adhe-
sive or softening paints.
When using the surface nozzle
(17), pay particular attention to the
heat development in adjacent loca-
tions of the cutting point. So that in
cases of doubt, no adjacent compo-
nent is overheated.

Spatula nozzle

Place the spatula nozzle (18) on the blow-
off pipe ( 1).
The spatula form of the nozzle serves the
purpose of the targeted hot air supply to
paint and lacquer surfaces. The paints and
lacquers can be removed with a spatula
and scraper. The spatula (18) itself is not
suitable for removing paint.

Grill lighter nozzle

Place the grill lighter nozzle (15) on the
blow-off pipe (
1).
Change the device with the step switch (
5) to level "3". Place the grill lighter nozzle
(15) below the charcoal. Make sure that
the openings of the grill lighter nozzle (15)
are not covered by charcoal as this creates
10
heat accumulation in the unit, which is a
potential fire hazard In just a few minutes
the charcoal is ignited.
Never use other methods for ignit-
ing charcoal at the same time while
using the grill lighter nozzle (15).
Use the grill lighter nozzle (15) only
for the few minutes necessary to
ignite the charcoal.
Never use the grill lighter nozzle
(15) for any other application.

Conical nozzle

For use as a weed killer, the device
may only be operated with the
extension pipe. When eliminating
weeds, hold the device by the
handle on the extension.
Place the conical nozzle (16) on the
blow-off pipe (
1).
Use the conical nozzle (16) to remove
weeds.
To eliminate weeds, use the conical
nozzle on the plant to be removed
for approx. 5-10 seconds.
For higher plants, you can shrink
them by briefly heating the upper
part of the plant. Then, use the coni-
cal nozzle on the shrunken plant for
5-10 seconds.
Initial start-up as a
weed killer
Mount the extension pipe to use the
device as a weed killer.