Checking the battery charge level
♦
Press the battery charge level button
to check the status of the battery. The status/
remaining charge will be shown on the battery
display LED
♦
RED/ORANGE/GREEN = maximum charge/
performance
RED/ORANGE = medium charge/performance
RED = low charge – charge the battery
Fixing/attaching the shoulder strap
♦
Hook the shoulder strap
lug
.
♦
Adjust the length of the shoulder strap
your size so that carrying lug
when hooked in place.
♦
In addition, you can adjust the height of the
carrying lug
on the appliance shaft
loosening the screw.
Mounting the saw chain and blade
WARNING!
►
Wear protective gloves! There is a danger
of injury from the sharp cutting teeth!
►
The sprocket cover
tensioning ring
are not pre-assembled on the appliance at
delivery.
►
The turning of the blade
the manufacturer.
►
The chain travel direction
must be adhered to every assembly.
♦
Place the saw chain
Ensure that
the saw chain
the correct direction.
♦
Attach the blade
upwards and guide the saw chain
the chain sprocket
The guide rail
must be above the blade
guide
.
♦
Put the sprocket cover
♦
Tighten the fixing screw
♦
Now, tighten the saw chain
Tightening and checking the saw chain).
♦
Tighten the fixing screw
│
GB │ IE │ NI │ CY
■
10
as follows:
into the carrying
to
is at hip height
together with the chain
and the fixing screw
is not intended by
on the blade
on the blade
.
is running in
with the labelling facing
around
.
on.
slightly.
(see section
completely.
Tightening and checking the saw
chain
WARNING!
►
Wear protective gloves! There is a danger of
injury from the sharp cutting teeth!
♦
Undo the fixing screw
♦
Turn the chain tensioning ring
direction to increase the tension.
♦
The saw chain
of the blade.
Check whether the saw chain
over the blade by hand
♦
Now tighten the fixing screw
NOTE
►
A new saw chain
by
tightened more regularly.
Lubricating the chain
♦
Remove the oil filler cap
♦
Fill the oil tank with approx. 65 ml of organic
chain oil
WARNING!
►
Never work without chain lubrication!
If the saw chain
equipment may become irreparably dam-
aged within a short time. Always check chain
lubrication and oil level
starting work.
NOTE
►
Use only saw chain oil. Preferably biodegrad-
able. Do not use waste oil, motor oil, etc.
►
While working, check whether the automatic
chain lubrication is working correctly. Check
the chain lubricator before and during work.
.
in a clockwise
must lie against the underside
can be drawn
.
completely.
stretches and must be
.
.
runs dry, the cutting
in the tank before
PAHE 20-Li A1