Mounting The Saw Chain And Blade; Tightening And Checking The Saw Chain; Lubricating The Chain; Sharpening The Saw Chain - Parkside PAHE 20-Li A1 Originalbetriebsanleitung

Mounting the saw chain and blade

WARNING!
► Wear protective gloves! There is a danger
of injury from the sharp cutting teeth!
► The sprocket cover
tensioning ring
are not pre-assembled on the appliance at
delivery.
► The turning of the blade
the manufacturer.
► The chain travel direction
blade must be adhered to every assembly.
♦ Place the saw chain
Ensure that the saw chain
the correct direction (see Fig. B).
♦ Attach the blade
upwards and guide the saw chain
the chain sprocket
The guide rail must be above the blade
guide (see Fig. C).
♦ Put the sprocket cover
♦ Tighten the fixing screw
♦ Now, tighten the saw chain

Tightening and checking the saw chain).

♦ Tighten the fixing screw
Tightening and checking the saw
chain
WARNING!
► Wear protective gloves! There is a danger of
injury from the sharp cutting teeth!
♦ Undo the fixing screw
♦ Turn the chain tensioning ring
direction to increase the tension.
PAHE 20-Li A1
together with the chain
and the fixing screw
is not intended by
on the
on the blade .
is running in
with the labelling facing
around
.
on.
slightly.
(see section
completely.
.
in a clockwise
♦ The saw chain must lie against the underside
of the blade.
Check whether the saw chain
over the blade by hand
♦ Now tighten the fixing screw
NOTE
► A new saw chain
tightened more regularly.

Lubricating the chain

♦ Remove the oil filler cap
♦ Fill the oil tank with approx. 65 ml of organic
chain oil .
WARNING!
► Never work without chain lubrication!
If the saw chain
equipment may become irreparably dam-
aged within a short time. Always check chain
lubrication and oil level
starting work.
NOTE
► Use only saw chain oil. Preferably biodegrad-
able. Do not use waste oil, motor oil, etc.
► While working, check whether the automatic
chain lubrication is working correctly. Check
the chain lubricator before and during work.

Sharpening the saw chain

NOTE
► You will find detailed information on
sharpening in the sharpening set, e.g. from
Oregon.
► Alternatively, you can use an electrical saw
chain sharpening device and follow the
instructions of the manufacturer.
► If you have any doubts about implementing the
work, the saw chain
can be drawn
.
completely.
stretches and must be
.
runs dry, the cutting
in the tank before
should be replaced.
GB │ CY │
11 ■