Additional Safety Information; Initial Start-Up - Parkside PLHLG 2000 B2 Originalbetriebsanleitung

GB IE NI
pull the mains plug out of the
socket if the mains cable is
damaged. If the connection
cable of this device is dam-
aged, it must be replaced
by the manufacturer or their
customer service or by a
similarly qualified person in
order to avoid hazards.
• Do not connect a damaged
mains cable to the power
supply. Do not touch a dam-
aged mains cable as long
as it is connected to the
power supply. A damaged
mains cable can result in
voltage-carrying parts being
touched.
Additional safety
information
Caution! Avoid injury, fire
and health risks:
• If in danger, immediately
remove the mains plug from
the socket.
• Never use the device as a
hair dryer
• Never direct the hot air flow
at people or animals.
• Do not look directly into the
nozzle opening on the blow-
off pipe.
• Do not touch the nozzle
when it is hot.
• Wear safety gloves.
• Wear safety goggles.
8
• Remove the mains plug from
the socket when not in use as
well as when taking a break
from working or while carry-
ing out work on the device,
e.g. changing the nozzle.
• Maintain distance between
the nozzle outlet and the
surface or workpiece you are
working on. The device could
overheat.
• The device must always be
kept clean, dry and free of
oil or lubricating greases.

Initial start-up

When used for the first time, some smoke
may escape. The smoke is caused by bind-
ers which are removed from the insulating
film of the heater by the heat during first
use. To ensure that the smoke escapes
quickly, the device should be placed on
the stand area (
the working environment during first use.
If the smoke/odour is too strong, move the
initial start-up to outside!
Initial Operation
The 2-in-1 long-reach hot air blower/weed
killer can be used as both a handheld
device (for operation as a hot air blower)
and as a long-reach tool (for operation as
a weed killer).
For use as a weed killer, the device
may only be operated with the
extension pipe. When eliminating
weeds, hold the device by the han-
dle on the extension.
20). Be sure to ventilate