Identification - Siko Lsc20 Originalbetriebsanleitung

LSC20
28

Identification

LASER
Invisible laser radiation
The use of optical instruments with this product will increase eye hazard.
` Do not view directly with optical instruments (Microscopes, Eye loupes
or magnifiers).
` Wavelength: 850 nm, max power 4.8 mW CW
` All maintenance procedures such as cleaning must be performed with
the encoder turned off.
` Do not insert any reflective surface into the beam path when the
encoder is powered.
` Do not attempt to service the encoder.
This product is sold solely for use as a component (or replacement) in an
electronic product; therefore it is not required to, and does not comply
with, CDRH 21 CFR 1040.10 and CDRH 1040.11 which pertain to complete
laser products. LSC20 contain an infrared laser diode or diodes. Emitted
invisible laser radiation levels have been measured to be within the CDRH
Class 1 range, which is not considered hazardous; however, to minimize
exposure to the diverging beam, the encoder sensor should be installed in
its operational configuration in close proximity to the encoder scale before
power is applied.
9 Identification
Please check the particular type of unit and type number from the identifi-
cation plate. Type number and the corresponding version are indicated in
the delivery documentation.
e. g. -
LSC20 0023
LSC20 · Date 08.07.2014 · Art. No. 87296 · Mod. status 012/14
version number
type of unit
English