Kärcher CB 2 exclusiv 23 Originalbetriebsanleitung Seite 30

Main switch
1 Main switch
2 Key switch (Option ABS counting sys-
tems)
3 Automatic/manual switch
The main switch is located at the feeder.
 Set main switch at "1" to put the plant
into operation.
ABS counting systems (Option)
The key switch can be used to select the
operating point from where the washing
programme can be started.
Position 0: Programme cannot be started,
Position 1: Programme can be started at
the wash card/code reader.
Position 2: Programme can be started at
the wash card/ code reader and at the con-
trol station.
Wash card/code reader (option)
The choice of the wash programme de-
pending on the design of the wash card/
code reader
– by entering on a keyboard,
– through the programme stated on the
wash card,
– by entering a code number.
Further information is obtainable in the sep-
arate operating instructions on the wash
card/code reader.
30
Control station for manual
operation (Option)
1 Emergency-stop button
2 Control supply voltage/normal position
button
3 Start key
The control station for manual operation
moves the plant components for mainte-
nance work to be done. This can also be
used to intervene when a wash programme
is in progress. In the case of a fault in the
wash card/code reader, the wash pro-
gramme can be also started.
Comfort control station (Option)
1 Emergency-stop button
2 Control supply voltage/normal position
button
3 Key: Lift roof brush or roof dryer.
4 Key: Unselect wheel washing
5 Key: drive out side-brushes
6 Key: Trigger stopping
7 Interrupt program key
8 Continue program key
9 Key "8" and pick-up
10 Keys Programme 1 to programme 7
The Comfort control station is used to start
washing programmes and for intervening in
an on-going washing programme. Further,
the plant components for carrying out main-
tenance tasks are moved.
5
-
EN
Service control station
The functions of this control station are de-
scribed in a separate operations manual.
This operations manual is delivered along
with the service control station.
Setting dosing pumps
e
b c
The dosing pumps dose the washing water
with the detergents shampoo (a), drying
aid/ hot wax (b) (option), foam/ hot foam (c)
(option), pre-spraying (d) (option) and hot
wax (e) in accordance with the wash pro-
gramme and the equipment of the plant.
Note:
The dosage amount is optimally set by the
fitter when the system is assembled. Gen-
erally no reset is necessary.
Set dosing amount
1 Ventilation lever
2 Ventilation button
3 Adjustment knob dosing volume
 Pull out the adjustment knob for the
dosing volume.
 Press and release the ventilation button
repeatedly and at the same time, rotate
the adjustment knob to the desired set-
ting.
 Release the ventilation key.
 Push in the adjustment knob for the
dosing volume.
d
a