Desiccant Bag; Setting Of The Led Illuminators And Synchronization Mode With The Camera; Description Of The Led Illuminator - Videotec ULISSE MAXI NETCAM Bedienungsanleitung

7.2.9 Desiccant bag

Insert the 2 desiccant bags (01) in the position
indicated in the illustration, after having taken them
out from the transparent packaging and folding them
in half. Fasten the sachets by means of the plates (02)
and screws supplied (03).
03
02
01
Fig. 46
MNVCUPTMAXIR_1430_EN
7.2.10 Setting of the LED illuminators
and synchronization mode with the
camera
Once the adjustment is done the
illuminator on the left (MASTER)
synchronizes and controls the illuminator
on the right (SLAVE).
The light sensitive switch detects the amount of
light in the environment and sends a signal to the
illuminator to switch on and off when the light has
reached the level set by the operator.
When the LED illuminators are active the camera
goes to night mode with the special ONVIF control.

7.2.10.1 Description of the LED illuminator

• Twilight sensor: Detects the light level.
• Cable: Power supply and control.
• Switch-on threshold regulator: This
potentiometer allows adjusting the sensitivity
threshold to switch on the illuminator.
• Infrared power control: This potentiometer allows
adjusting the power of the illuminator.
Twilight sensor
Switch-on threshold
regulator
Fig. 47
Cable
Infrared power control
27