Machine Parameters - Intermittent Mode; Layout Settings - Carl Valentin FLEXICODE Schnellreferenzhandbuch

Key:
Encoder resolution /
material feed per encoder
rotation
Key:
Material speed
Intermittent Mode
Mode
Key:
Back speed
Key:
Print offset
Key:
Print position
Key:
Layouts/cycle

Layout Settings

Keys: , , ,
Print length
Key:
Column printing
Key:
Material selection
Key:
Invert layout
Key:
Flip layout
Indication of resolution of used encoder and material feed per rotation of encoder in mm. These
settings help measuring the material speed.
The material feeding per encoder rotation corresponds for instance, in a 1:1 translation between
the encoder and the roller, to the roller circumference.
Indication of material speed (only for reading purposes).
Selection of operating mode (number of pieces, continuous mode, test mode, direct start).
Indication of back speed of print mechanics after print end in mm/s.
Value range: 50 ... 600 mm/s.
Indication of distance of the layout (res. the first layout in case more layouts per cycles are to be
printed) to the zero point of machine.
Value range: 0 ... 999 mm
Default: 0 mm
Indication of start position of print carriage in mm.
Value range: 0 ... 43 mm
Default: 3 mm
Indication of the number of printed layouts per print start (cycle).
Value range: 1 ... 25.
Indication of way which the print mechanics has to move. The print length depends on the length
of the print mechanics.
Indication of width of one layout as well as how many layouts are placed side by side.
Selection of the used print materials.
On: Layout is printed inverse.
Off: Function is deactivated.
The axis of reflection is in the middle of the layout. If the layout width was not transferred to the
print module, automatically the default layout width i.e. the width of the printhead is used. It is
recommended to use layouts with the same width as the printhead. Otherwise this can cause
problems in positioning.
English
Flexicode
113