Loading Label Roll In Tear-Off Mode - Carl Valentin Vita II Serie Kurzanleitung

Loading label roll in tear-off mode

H
G F
•
Open the printer cover.
•
Open printhead (G) by turning the red pressure lever (F) anticlockwise.
•
Remove the outside label mounting plate (A).
•
Load the label roll with inner winding onto the unwinding roll (B) and attach again the label mounting plate (A).
•
Lead the label material below the return pulley (C) and the printhead (G).
Pay attention that the label runs through the photocell (E).
•
In order to move the printhead (G) down, turn the red pressure lever (F) in clockwise direction until it locks.
•
In front of the printhead you can see the tear off (H) from which you can rip off labels to the bottom.
•
Enter the offset value in the menu Print settings/Tear-off.
•
Adjust the adjusting ring (D) of the return pulley (C) to the width of material.
•
Close the printer cover.
E D C
A
English
Vita II
B
91