Yamaha CDRHD1500 Bedienungsanleitung Seite 607

5.
Push the HDD tray and connect the IDE cable and the
power cable.
• Make sure that the terminals and connectors are in the correct
direction, and connect the cables securely.
• Static electricity can damage the HDD. Be careful not to
touch the terminal pins and the circuit board.
• Do not apply excessive force on the HDD tray.
Power cable
IDE cable
6.
Close the HDD slot door and tighten the two fixing
screws on the HDD slot door.
Fixing screws
■ Formatting the HDD
If you install a new HDD, you need to format the HDD before
using with this unit.
1.
Connect the AC power cable to the wall outlet and
turn on the power of this unit.
"Format Start?" appears on the display.
2.
Press w/d.
"Format Really" appears on the display.
3.
Press w/d.
"Push PLAY KEY" appears on the display.
4.
Press w/d.
"Wait" flashes on the display. After a few seconds, this unit
starts formatting of the HDD. It takes approximately 15
seconds to complete formatting.
5.
When formatting has been completed, "Format OK"
appears on the display. Then the display returns to
the one when the power of this unit was turned on.
Note
You do not need to format the HDD when using a HDD formatted
with this unit. When using a HDD formatted with another
CDR-HD1500 or other device, follow "Formatting the HDD (HDD
Format" (P.72) of "CDR-HD1500 Owner's Manual".
■ Recommended HDDs
We have checked the compatibility with CDR-HD1500 for the
following model (as of March, 2005):
• Seagate Baraccuda 7200.7 Series/ST3160021A (160GB)
(Company and product names are trademarks of their respective
company.)
For additional information on HDDs, see your local YAMAHA
authorized dealer.
2