Cleaning And Maintenance; Disposal - Parkside X18V Bedienungs- Und Sicherheitshinweise

Preparing the tool for use / Cleaning and Maintenance / Disposal
Hard screw bed:
j
Particularly high torques can occur, for example
with metal screws tightened by socket tool bits.
Select a lower rotation speed.
Soft screw bed:
j
You should also select a low speed in order not
to damage the wood workpiece surface through
contact with the metal screw head. Use a coun-
tersinker.
When drilling into wood, metal and other
materials, take note of the following advice:
j
With small diameter drill bits use a high drill
speed. for large diameter drill bits, use a low
drill speed.
j
for hard materials, select a low drill speed.
for soft materials, select a high drill speed.
j
Secure or fix down the workpiece (if possible)
in a clamp or vice.
j
Mark the intended position of the hole with a
centre punch or a nail and select a low drill speed
for drilling.
j
Take the rotating drill bit out of the hole frequently
so that swarf or drill dust can be re-moved and
the hole and tool is ventilated.
Drilling in metal:
j
Use a metal drill bit (HSS). for the best results,
you should cool the bit with oil. Metal drill bits
can also be used to drill into plastic.
Drilling in stone:
j
Use a circular shafted masonry drill bit with a
hardened metal tip.
Drilling in wood:
j
normally you should use a wood drill with a
centring point. for deep holes, use an auger type
bit. for large diameter holes, use a forstner bit.
You can screw small screws into soft wood
without the need for pre-drilling.

Cleaning and Maintenance

Q
m CAUTION! Place the direction of rotation
switch into the middle position before carry-
3
ing out any tasks on the device, e.g. changing
tools or maintenance, or before transporting or
storing the device. Inadvertent operation of the
On / Off switch
4
Pull the mains lead out of the mains socket every
time and remove the battery before you clean or
maintain the device.
The Cordless Drill / Screwdriver is maintenance-free.
j
Always keep the device clean, dry and free of
oil or grease.
j
Clean the device immediately after you have
finished using it.
j
Do not allow any liquids to enter the device.
Use a cloth to clean the housing. never use
petrol, solvents or cleaning agents that might
attack plastic.

Disposal

Q
The packaging comprises exclusively en-
vironmentally-friendly material. Dispose
of it in your local recycling containers.
Do not dispose of electrical
appliances with your
domestic waste!
According to the European Directive 2002 / 96 / EG,
concerning used electrical and electronic appliances
and its implementation in national law, superannu-
ated electrical appliances must be collected and
disposed of via an environmentally suitable recy-
cling facility.
Defective or worn out rechargeable batteries must
be recycled according to Directive 91 / 157 / EEC.
In this regard, read the special safety notices for
charging stations and battery packs.
may result in injury.
GB/IE/CY 13