Using The Appliance; Switching On/Off; Lubrication; Cutting Process - Parkside PMKA 20-Li A1 Originalbetriebsanleitung

Using the appliance

Switching on/off
Switching on the appliance
♦ Move the ON/OFF switch
Switching off the appliance
♦ Move the ON/OFF switch

Lubrication

♦ Apply standard machine oil to the cutting line
to extend the service life of the grooved pin
and the die . This is particularly important
when cutting aluminium.

Cutting process

♦ Hold the appliance at a right angle (90°) to
the workpiece during the machining process.
♦ Move the appliance in the cutting direction
with gentle pressure.

Cut-outs

For internal cut-outs, a hole larger than 22 mm
is needed to insert the die holder

Maintenance and cleaning

WARNING! RISK OF INJURY! Switch
the appliance off and remove the
power plug before starting any work
on the appliance.
■ The appliance must always be kept clean, dry
and free from oil or grease.
■ Use a soft, dry cloth to clean the housing.
Never use petrol, solvents or cleansers which
can damage plastic.
■ If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level is
between 50% and 80%. The optimum storage
environment is cool and dry.
PMKA 20-Li A1
Kompernass Handels GmbH
warranty
Dear Customer,
This appliance has a 3-year warranty valid from
to position "0".
the date of purchase. If this product has any faults,
you, the buyer, have certain statutory rights. Your
statutory rights are not restricted in any way by the
to position "I".
warranty described below.
Warranty conditions
The warranty period starts on the date of purchase.
Please keep your receipt in a safe place. This will
be required as proof of purchase.
If any material or manufacturing fault occurs within
three years of the date of purchase of the product,
we will either repair or replace the product for you
or refund the purchase price (at our discretion).
This warranty service requires that you present the
defective appliance and the proof of purchase (re-
ceipt) within the three-year warranty period, along
with a brief written description of the fault and of
when it occurred.
If the defect is covered by the warranty, your
.
product will either be repaired or replaced by us.
The repair or replacement of a product does not
signify the beginning of a new warranty period.
X 12 V and X 20 V Team Series battery packs
come with a 3-year warranty valid from the date
of purchase.
Warranty period and statutory claims
for defects
The warranty period is not prolonged by repairs
effected under the warranty. This also applies to
replaced and repaired components. Any damage
and defects present at the time of purchase must
be reported immediately after unpacking. Repairs
carried out after expiry of the warranty period shall
be subject to a fee.
GB │ IE │ 9 ■