Specific Safety Instructions For The Pneumatic Cleaning Gun; Operation; Before Use - Parkside PDRP 6.2 A1 Originalbetriebsanleitung

... /Specific safety instructions for the pneumatic cleaning gun / Operation
out of the work area while the
device is being used. If you are
distracted, you could lose control
of the device.
Wear appropriate clothing. Do
„ z
not wear loose clothing or jew-
ellery. Keep hair, clothing and
gloves away from moving parts.
Loose clothing, jewellery or long
hair could become trapped inside
moving parts.
Always ensure that hoses and pip-
„ z
ing are regularly drained of con-
densate (water) before and after
using the pneumatic device. The
best solution here is to use a con-
densate separator.
A compressed air system that
„ z
is not powerful enough can make
your device less efficient.
Never point the pneumatic device
„ z
at yourself, other people or ani-
mals. Water is ejected from the
device at high pressure and high
speed. This can be extremely dan-
gerous.
SPECIFIC SAFETY
INSTRUCTIONS FOR THE
PNEUMATIC CLEANING GUN
Do not use force to activate the
„ z
trigger .
3
Ensure that all parts have been
„ z
fitted securely before using the
pneumatic cleaning gun.
Wear appropriate protective
„ z
clothing when working with the
pneumatic cleaning gun: as a
minimum, this should include
hearing protection, protective
goggles and work gloves.

OPERATION

Before use

z z
After opening the package, immediately check to
ensure that the package contents are complete and
undamaged. Contact your dealer immediately if the
package contents is incomplete or has any defects.
Do not use the device if it is defective.
The device is supplied fully assembled. The brush
is screwed onto the outlet nozzle
7
Connect the pneumatic cleaning gun to a
compressor by connecting the compressed air
2
connection fitting on the pneumatic cleaning
gun to the supply line from the compressed air
source. To be able to control the air pressure, the
compressed air supply must be equipped with a
pressure regulator. The working pressure of the
cleaning gun is a constant 6.2 bar (max.) at the
device. The volumetric flow rate is 3 to 4.5 bar.
Fill the cleaning liquid tank
target mark. The maximum water temperature is 30
°C. Please also follow the instructions from the
detergent manufacturer. If a lower temperature is
specified, use water only at this lower temperature.
If required, you can add a non-foaming detergent
that can be diluted with water. For the exact mixing
ratio, please consult and follow the manufacturer's
instructions.
Do not use any alkaline detergents, detergents
containing acids or inflammable detergents.
The pneumatic cleaning gun atomises the cleaning
.
6
4
with water to the
GB/IE/NI 11